LIFTALL – USA 4100-0040 Roughneck Heavy Duty Wire Mesh Sling 6″ x 6′ Mesh Gage 10 Sling Type 1

LIFTALL – USA 4100-0040 Roughneck Heavy Duty Wire Mesh Sling 6″ x 6′ Mesh Gage 10 Sling Type 1

LIFTALL – USA 4100-0040 Roughneck Heavy Duty Wire Mesh Sling 6″ x 6′ Mesh Gage 10 Sling Type 1 widely used in metalworking shops and steel warehouses where loads are abrasive, hot or tend to cut web.

• All-steel construction resists cutting and abrasion
• Galvanized high tensile 10-gauge steel mesh assures long service life
• Low stretch and good flexibility to conform to load
• Permanently stamped with capacity rating for quick identification
• Can be used in temperatures up to 550°F
• Factory repairable for cost savings
• Great for steel warehouse and metal fabrication shops
• Proof tested and certified
• Rated capacity (lb.): 7,200 vertical, 7,200 choker, 14,400 basket
• Complies with OSHA and ASME standards
Standard Construction: Alloy steel end fittings, zinc
plated. Mesh is galvanized high tensile steel. 10 gage
is standard, 12 gage is available upon request

* Vertical & choker load capacity 7200 lbs
* Made in USA

Note: Do not exceed official rated capacity

From our beginning in 1964, Lift-All® has grown to become the largest and most well known sling manufacturer in North America. We manufacture the most complete line of slings available, and will custom build whatever is needed for your specific application. Numerous below-the-hook lifting devices are available, and we manufacture a full line of tie down assemblies.

Our products are sold through only the finest industrial distributors and contractor supply houses. To make sure you’re getting the best products for overhead lifting and load securement, be sure to specify Lift-All^®!